Cisco switch stack issue (DS-101)

Earlier this evening we identified one of our Cisco switch stacks misbehaving causing a constant stream of stack reconverges – this constant reconverge event has been causing layer 2 network instability for traffic flowing via the stack of nine switches.

We have just completed a physical inspection of all stack cables, including full reseating of cables as per Cisco’s guidelines – however the problem still persists.

It is possible that the stack issues are caused via a software fault within the Cisco IOS software.

We are currently applying an upgrade to the switch stack and will reboot the full stack afterwards to activate the changes.

Cisco advise doing this as a full cold reboot by removing the power from the stack members so this reload will take longer than usual.

 

Any customers connected to a different switch stack will only see a momentary outage during a layer 2 reconvergence.

Customers directly connected to switch stack DS-101 will see a total outage for up to 15 minutes.

Generator Tests – BOL

After a minor change in operating procedure, we briefly neglected to post the results of our weekly generator tests. For completeness, here’s a list of the intervening tests…

28-08-2016
BOL1  10:12 - 10:38  Off load  Passed
BOL2  10:56 - 11:13  Off load  Passed

05-07-2016
BOL1  10:24 - 10:42  On load   Passed
BOL2  10:53 - 11:16  On load   Passed

12-07-2016
BOL1  10:20 - 10:49  Off load  Passed
BOL2  11:02 - 11:22  Off load  Passed

19-07-2016
BOL1  10:15 - 10:25  Off load  Passed
BOL2  10:55 - 11:14  Off load  Passed

28-07-2016
BOL1  10:08 - 10:32  Off load  Passed
BOL2  10:41 - 11:03  Off load  Passed

The generator was started, then ran off-load / on-load for the durations given above, before detecting mains and shutting down in the expected timeframe.
All measured values were within their normal ranges.